Levelone WAB-6120 User Manual download pdf (Page 27)

Chapter 3 Basic Settings Page 17

Basic System Settings

For users who use the LEVELONE 150MBPS WIRELESS POE AP for the first time, it is

recommended that you begin configuration from “Basic Settings” in “System” shown below:

Figure 14 Basic System Settings

Basic Settings

Network Mode: Specify the network mode, including Bridge and Router. It is easy to configure

parameters in Bridge Mode; however, users must pay extra attention to the way they configure the

device when it is set to Router Mode. For details, please refer to “IP Settings (Router)”.

Device Name: Specify the device name, which is composed of no more than 15 characters with

(0-9), (A-Z), (a-z) or (-).

Country Region: The availability of some specific channels and/or operational frequency bands

is country dependent.

IP Settings (Bridge)

This is available only under Bridge network mode. Open “IP Settings (Bridge)” in “System” as

below to configure the parameters for LAN which connects to the LAN port of LEVELONE

150MBPS WIRELESS POE AP. In this page, users may change the settings for IP Address,

Subnet Mask, and DHCP Server.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 64 65

No comments

Levelone WAB-6120 User Manual Page 27