LevelOne FSW-1611TX 16Port 10/100Mbps 13” Fast Ethernet Switch USER'S GUIDE
10 Note: To reset the switch, Remove the power cord and re-attach it . a) The switch must be reset when the MAC Address table needs to be rebuilt. b)
11 C. INSTALLATION This LevelOne 16Port 10/100Mbps 13” Fast Ethernet Switch is "Plug & Play." They do NOT require software configura
12 2. Use the other provided screws to secure the Switch to the rack.
13 D. HELPFUL SUGGESTIONS Prior to Installation Before installing this LevelOne FSW-1611TX 16Port 10/100Mbps 13” Fast Ethernet Switch and connect
14 they can receive data. • In Full-Duplex mode data can be transmitted and received at the same time. However: a) Full-Duplex transmission is on
15 10Mbps, with Auto-Negotiation 20Mbps Bandwidth (10BASE-T, Full-Duplex) F Helpful Warning: If the attached device is set to a fixed mode (ex: For
16 E. Troubleshooting I. Link LED does not lit after cable is connected to the port. Ø Verify that the other end of the cable is connected to a dev
17 ALWAYS CHECK THAT: Ø CABLE AND LINK DISTANCES ARE WITHIN THE NETWORK'S SPECIFICATIONS Ø OVERALL NETWORK DIAMETERS ARE WITHIN THE NETWORK&a
18 F. PRODUCT SPECIFICATIONS Models FSW-1611TX Standards • 100BASE-TX IEEE 802.3u • 10BASE-T IEEE 802.3 Ports • Sixteen (16) 100BASE-TX/10BASE-T
2 FCC WARNING This equipment has been tested and found to comply with the limits for a Class A computing device pursuant to Part 15 of FCC Rules, whic
3 TABLE OF CONTENTS UNPACKING INFORMATION-----------------------------------4 PRODUCT INTRODUCTION-------------------------------------5 FAST ETHERNET
4 A. UNPACKING INFORMATION Thank you for purchasing LevelOne FSW-1611TX 16Port 10/100Mbps 13” Fast Ethernet Switch. Before continuing, please check
5 B. PRODUCT INTRODUCTION This chapter describes the features of the Switch and some background information about Ethernet/Fast Ethernet switching t
6 segments. The switch, without interfering with any other segments, automatically forwards traffic that needs to go from one segment to another. By
7 The Switches are a perfect choice for site planning to upgrade to Fast Ethernet in the future. Ethernet workgroups can connect to the Switches now,
8 The Front Panel LevelOne 16Port 10/100Mbps 13” Fast Ethernet Switch Port Speeds 100/10Mbps TP Ports Each 100/10Mbps TP port provides an Auto-Nego
9 cabling. Status LEDs This LevelOne 16Port 10/100Mbps 13” Fast Ethernet Switch comes with a complete range of LEDs. The table below lists each L
Comments to this Manuals