POI-2001 & POS-1001 Gigabit PoE Injector & Splitter POI-2002 & POS-1002 PoE Injector & Splitter POI-3004 Gigabit PoE Injector
Installation Steps Connect AC Power cord to the PoE Injector, and "Power" LED will light up. Schließen Sie das Netzkabel an den
Connect "Data/In" port of Injector to Non PoE switch via Cat.5e/6/7 cable, and set the correct voltage (5V, 9V or 12V) by adjustable
Conecte a porta "Data/In" (Dados/Entrada) do injector ao switch não PoE através de um cabo Cat.5e/6/7 e defina a voltagem correcta (5V
Συνδέστε την “Power + Data” θύρα του Splitter και την “P+D/out” θύρα του Injector με ένα Ethernet καλώδιο, και σιγουρευτείτε πως το “Power” LED
(gegevensuitgang) van de splitter aan op de RJ45-poort van het netwerkapparaat. (Zorg dat u de juiste verwisselbare pen kiest voor het aandrijven
Check whether the network device is on. If not, please make sure that power is on for Injector and Splitter, and all cables are connected corre
Connection Diagram:
Comments to this Manuals