Levelone IES-0820 User Manual download pdf (Page 13)

IES-0820 User Manual Page 12

Connecting to Your Network

Cable Type & Length

It is necessary to follow the cable specifications below when connecting the switch to your

network. Use appropriate cables that meet your speed and cabling requirements.

Cable Specifications

Speed Connector Port Speed

Half/Full Duplex

Cable Max. Distance

10Base-T RJ-45 10/20 Mbps 2-pair UTP/STP Cat. 3, 4, 5 100 m

100Base-TX RJ-45 100/200 Mbps 2-pair UTP/STP Cat. 5 100 m

1000Base-T RJ-45 2000 Mbps 4-pair UTP/STP Cat. 5 100 m

100Base-FX ST, SC 200 Mbps MMF (62.5μm) 2 km

100Base-FX ST, SC 200 Mbps SMF (10μm) 20, 40, 75, 100 km

100Base-BX SC 200 Mbps MMF (62.5μm) 2, 5 km

100Base-BX SC 200 Mbps SMF (10μm) 20, 40 km

1000Base-SX SC 2000 Mbps MMF (62.5μm) 220 m, 2 km

1000Base-SX SC 2000 Mbps MMF (50μm) 550 m

1000Base-LX SC 2000 Mbps SMF (10μm) 10, 20, 50 km

1000Base-BX SC 2000 Mbps SMF (10μm) 20, 40 km

SFP

1000Base-SX Duplex LC 2000 Mbps MMF (62.5μm) 550 m, 2 km

1000Base-LX Duplex LC 2000 Mbps SMF (9μm) 10, 40, 60 km

1000Base-BX Duplex LC 2000 Mbps SMF (9μm) 70 km

Cabling

Step 1: First, ensure the power of the switch and end devices are turned off.

<Note> Always ensure that the power is off before any installation.

Step 2: Prepare cable with corresponding connectors for each type of port in use.

Step 3: Consult the previous section for cabling requirements based on connectors and

speed.

Step 4: Connect one end of the cable to the switch and the other end to a desired

device.

Step 5: Once the connections between two end devices are made successfully, turn on

the power and the switch is operational.

1 2 ... 8 9 10 11 12 13 14 15 16

No comments

Levelone IES-0820 User Manual Page 13