LevelOne FCS-5011 User Manual download pdf (Page 60)

Enable WDR (Wide Dynamic Range):

Select it to enable the WDR function. This Network Camera with WDR feature can cope with

very challenging lighting conditions. It is capable of capturing both of the dark part and bright

part of a target and combining the differences into a scene to generate a highly realistic image

as the human eyes can see. Note that if you select this function, Exposure level and AGC

function will be disabled.

Switch to B/W in night mode:

Select it to enable the Network Camera to automatically switch to B/W in night mode.

IR cut filter:

With a removable IR-cut filter and built-in IR illuminators, up to 15m, this Network Camera can

automatically remove the filter and turn on the IR illuminators during the nighttime to accept IR

illumination for low light sensitivity.

■ Auto

The Network Camera automatically removes the filter by judging the level of ambient light.

■ Schedule mode

The Network Camera switches between day mode and night mode based on specified

schedule. Enter the starting time and ending time for the day mode. Note that the time format

is [hh:mm] and is expressed in 24-hour clock time. By default, the starting time and ending

time of day mode are set to 07:00 and 18:00.

■ Day mode

In day mode, the Network Camera switches on the IR cut filter at all times to block the

infrared light from reaching the sensor so that the colors will not be distorted.

■ Night mode

In night mode, the Network Camera switches off (remove) the IR cut filter to allow the

infrared light to pass through. This improves the sensitivity of the Network Camera in

low-light conditions.

You can click Preview to fine-tune the image, or click Restore to recall the original settings

without incorporating the changes. When completed with the settings on this page, click Save

to take effect and click Close to quit the page.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 118 119

No comments

LevelOne FCS-5011 User Manual Page 60