Levelone GTL-2690 User Manual Page 338

  • Download
  • Add to my manuals
  • Print
  • Page
    / 789
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 337
Configuring Static Routes
19-21
19
Configuring Static Routes
This router can dynamically configure routes to other network segments using
dynamic routing protocols (i.e., RIP or OSPF). However, you can also manually
enter static routes in the routing table. Static routes may be required to access
network segments where dynamic routing is not supported, or can be set to force the
use of a specific route to a subnet, rather than using dynamic routing. Static routes
do not automatically change in response to changes in network topology, so you
should only configure a small number of stable routes to ensure network
accessibility.
Command Usage
Up to 64 static routes can be configured.
If a static route is defined, it will always take preference over a dynamic route.
Static routes are included in RIP and OSPF updates periodically sent by the router
if this feature is enabled by the RIP or OSPF (see page 20-9 or 20-35,
respectively).
Command Attributes
Interface – Index number of the IP interface.
IP Address – IP address of the destination network, subnetwork, or host.
Netmask – Network mask for the associated IP subnet. This mask identifies the
host address bits used for routing to specific subnets.
Gateway – IP address of the next router hop used for this route.
Metric – Cost for this interface. (Range: 1-5, Default: 1)
The metric is an administrative distance, and indicates that this route can be
overridden by dynamic routing information if the distance of the dynamic route is
less than that configured for the static route. Note that the default administrative
distances used by the dynamic unicast routing protocols is 110 for OSPF and 120
for RIP.
Entry Count – The number of table entries.
Page view 337
1 2 ... 333 334 335 336 337 338 339 340 341 342 343 ... 788 789

Comments to this Manuals

No comments