Levelone GTL-2690 User Manual Page 678

  • Download
  • Add to my manuals
  • Print
  • Page
    / 789
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 677
41-1
Chapter 41: IP Interface Commands
An IP address may be used for management access to the router over your network
or to connect the switch to existing IP subnets. An IPv4 address is obtained via
DHCP by default for VLAN 1. You can also manually configure a new address for
other VLANs on the router to enable management access through these VLANs or
to connect the router to existing IP subnets. You can manually configure a specific
IPv4 or IPv6 address, or direct the router to obtain an IPv4 address from a BOOTP
or DHCP server when it is powered on. Both IP Version 4 and 6 addresses can be
defined and used simultaneously to access the router. An IPv6 address can either
be manually configured or dynamically generated. You may also need to a establish
an IPv4 or IPv6 default gateway between this device and management stations or
other devices that exist on another network segment (if routing is not enabled).
This section includes commands for configuring IP interfaces, the Address
Resolution Protocol (ARP) and Proxy ARP. These commands are used to connect
subnetworks to the enterprise network.
Basic IP Configuration
This section describes commands used to configure IP addresses for VLAN
interfaces on the switch.
Table 41-1 IP Interface Commands
Command Group Function Page
Basic IP Configuration Configures the IP address for interfaces and the gateway router 41-1
Address Resolution
Protocol (ARP)
Configures static, dynamic and proxy ARP service 41-32
Table 41-2 Basic IP Configuration Commands
Command Function Mode Page
IP Version 4
ip address Sets the IP address for the current interface IC 41-3
ip default-gateway Defines the default gateway through which this router can reach
other subnetworks
GC 41-4
show ip interface Displays the IP settings for this device PE 41-5
show ip redirects Displays the default gateway configured for this device PE 41-5
ping Sends ICMP echo request packets to another node on the network NE, PE 41-6
Page view 677
1 2 ... 673 674 675 676 677 678 679 680 681 682 683 ... 788 789

Comments to this Manuals

No comments