LevelOne ProCon GSW-2692 User Manual download pdf (Page 180)

Command Line Interface

4-2

Note: The IP address for this switch is obtained via DHCP by default.

To access the switch through a Telnet session, you must first set the IP address for

the Master unit, and set the default gateway if you are managing the switch from a

different IP subnet. For example,

If your corporate network is connected to another network outside your office or to

the Internet, you need to apply for a registered IP address. However, if you are

attached to an isolated network, then you can use any IP address that matches the

network segment to which you are attached.

After you configure the switch with an IP address, you can open a Telnet session by

performing these steps:

1. From the remote host, enter the Telnet command and the IP address of the

device you want to access.

2. At the prompt, enter the user name and system password. The CLI will display

the “Vty-n#” prompt for the administrator to show that you are using privileged

access mode (i.e., Privileged Exec), or “Vty-n>” for the guest to show that you

are using normal access mode (i.e., Normal Exec), where n indicates the

number of the current Telnet session.

3. Enter the necessary commands to complete your desired tasks.

4. When finished, exit the session with the “quit” or “exit” command.

After entering the Telnet command, the login screen displays:

Note: You can open up to four sessions to the device via Telnet.

Console(config)#interface vlan 1

Console(config-if)#ip address 10.1.0.254 255.255.255.0

Console(config-if)#exit

Console(config)#ip default-gateway 10.1.0.254

Username: admin

Password:

CLI session with the GSW-2692 24-Port 10/100M + 2G Combo L2

Stackable Switchis opened.

To end the CLI session, enter [Exit].

Vty-0#

1 2 ... 175 176 177 178 179 180 181 182 183 184 185 ... 389 390

No comments

LevelOne ProCon GSW-2692 User Manual Page 180